Tag Archives: turret software

CNC Punch Turret Software | Making Formed Features

Punch Nesting Formed Parts

Punch Nesting Formed Parts

If you are running CNC punch presses or turret punch, you may already be intimately aware of the challenges faced when programming formed features.  If not, you may be wondering if creating formed features is a viable option or how it’s done with a CNC punch press.

Either way, today’s discussion is all about cracking open the mystery behind forming features from sheet metal that can only be achieved with CNC punching.  Our discussion will roll out along these lines. We’ll first define what formed features are, then look at the issues encountered in programming them, the problems created when the program isn’t done right, and finally, we’ll wrap this up with the solution you may be looking for to this sticky challenge. Read more …

New Nesting Process Cut Delivery from 8 Days to 8 Hours

Cutting Delivery Time with Nesting Process

Cutting Delivery Time with Nesting Process

We recently met a manufacturer, who struggled to get product out in a timely fashion.  If that sounds familiar, read on.  Here is his story.

Before: Order to Delivery in About A Week

This manufacturer of large industrial equipment had an established shear-to-blank, then punch process that went something like this.

An order would come in for 50 of the same part.  The part blanks would be sheared from 10 very large sheets.  This means the shear operator would 1) make two trim cuts per large sheet to square the raw material, 2) measure and cut the first blank, 3) make sure it is square and accurate, 4) repeat four more times per large sheet.  Then he would move and stack the 50 small sheets beside the punch ready for punching the internal holes.  Are you seeing how this could be time consuming and slow delivery times? Read more …